1. Unscrew the battery plate screws
1
；
2. Remove battery plate
2
；
3. Pull the terminal rubber covers off；
4. Remove terminal screw and disconnect black
(negative) cable first.
5. Remove the terminal screw and disconnect red
(positive) cable.
6. Remove battery from the ATV.
Battery Charging
CAUTION
When charging, the 12V batteries produce hydrogen,
combustible and explosive gas. Therefore, please follow
the following precautions before battery charging:
If charging battery which is still installed in the ATV, be
sure to disconnect the ground cable.
Make sure the charger is off when connecting and
disconnecting the clamps to the battery.
Only charge slowly (5A or less). If charged quickly, the
batteries may explode.
To Next Page
Loading...
