CVT clutch / Drive belt
Proper break-in of the CVT clutch and drive belt will
ensure longer life and better performance. Break-in the
clutch and drive belt at low speeds for the recommended
period, with pulling only light loads. Avoid violent
acceleration and high-speeds during break-in period. If the
drive belt is broken, be sure to clean also the intake and
outlet ducts. Take out any debris from the clutch and
engine compartment when belt is replaced.
Mounting the ATV
1. Wear protective riding gear. See the Safe Riding
Gear section.
2. Perform the pre-ride inspection.
3. Place the transmission in Park.
4. Mount the vehicle from the left side.
5. Sit upright with both feet on the footrests and both
hands on the handlebars.
6. Start the engine and allow it to warm up.
7. Drive slowly. Practice maneuvering and using the
throttle and brakes on flat surfaces.
To Next Page
Loading...
