HANDLEBARS ADJUSTMENT
The handlebars can be adjusted to suit your needs.
1
M8×48 (4x)
Handlebar bolts tightening torque: 35 Nm
1. Loosen the four handlebar bolts.
2. Adjust the handlebars position according to your
preferences.
3. Tighten the two front bolts, then tighten the two
rear bolts. Leave a gap of 3 mm at the back of the
clamp block.
4. Tighten all screws and check that handlebars do not
restrict the steering.
Improper adjustment of the handlebars or improper
torque of tightening bolts can result in limited steering or
loose handlebars; loss of control can result in severe injury
or death. Always follow correct adjustment procedure, or
visit Segway Powersports Authorised service.
To Next Page
Loading...
