Segway x2 SE - LeanSteer Frame Removal and Installation

Segway Personal Transporter SE Service Manual
1–5
LeanSteer Frame
Removal
Tool Required: 5 mm hex wrench
1. Make sure the PT is powered off and unplugged.
2. Using a 5 mm hex wrench, remove the two fasteners
holding the LeanSteer Frame to the LeanSteer Stem
(see Figure 1–5), while supporting the LeanSteer
Frame.
3. Remove the LeanSteer Frame.
Installation
Tools Required: 5 mm hex wrench
Torque wrench
1. Make sure the PT is powered off and unplugged.
2. Place the LeanSteer Frame onto the LeanSteer Stem
(see Figure 1–5).
3. Using a 5 mm hex wrench, install the two fasteners.
Torque to 11.0 N-m (8.1 ft-lbf).
4. With the PT powered down (OFF), lean the LeanSteer
Frame fully left and right, until it touches each
fender (see Figure 1–6).
5. Ensure the LeanSteer Frame returns to a straight,
upright position. If it is not vertical, follow the
instructions on page 1–6 to remove and install the
LeanSteer Stem.
6. Check the fasteners to be sure they are tight.
NOTICE
Check the fasteners at least monthly to be sure they
remain tight. If they are loose, tighten the fasteners
to 11.0 N-m (8.1 ft-lbf).
7. Perform post-service tests (page A–1).
Figure 1–5: LeanSteer Frame
Figure 1–6: Check LeanSteer Frame
LeanSteer
Stem
LeanSteer Frame
23517-00001
11.0 N-m (8.1 ft-lbf)
LeanSteer