Segway Personal Transporter SE Service Manual
1–7
InfoKey Controller
Removal
1. Press the release tab at the bottom of the InfoKey
Dock. See 1 in Figure 1–9.
2. Slide the InfoKey Controller out of the Dock.
See 2 in Figure 1–9.
Installation
1. Make sure the InfoKey Dock is installed (see
page 1–7).
2. Place the InfoKey Controller onto the Dock and slide
into place until the release tab (1 in Figure 1–9) is
engaged.
3. Perform post-service tests (page A–1).
Figure 1–9: Remove InfoKey Controller
InfoKey Controller
InfoKey Dock
InfoKey Dock
Removal
Tool Required: 3 mm hex wrench
1. Make sure the PT is powered off and unplugged.
2. Using a 3 mm hex wrench, remove the fastener that
holds the InfoKey Dock to the LeanSteer Frame.
See Figure 1–10.
3. Remove the InfoKey Dock.
Installation
Tools Required: 3 mm hex wrench
Torque wrench
1. Make sure the PT is powered off and unplugged.
2. Place the InfoKey Dock against the upper LeanSteer
Frame with the release tab oriented toward the
bottom. See Figure 1–10.
3. Using a 3 mm hex wrench, install the fastener
through the hole in the InfoKey Dock and into
the upper LeanSteer Frame. Torque to 2.0 N-m
(18 in-lbf).
4. Perform post-service tests (page A–1).
20306-00003
2.0 N-m (18 in-lbf)
InfoKey Dock
Figure 1–10: InfoKey Dock
LeanSteer
To Next Page
Loading...
