Segway Personal Transporter SE Service Manual
9–10
Console
Front Light Pipe
Removal
Tool Required: T-10 6-lobe wrench
1. Make sure the PT is powered off, unplugged, and the
batteries have been removed.
2. Establish a Serviceable Powerbase (page 8–2).
3. Remove the Radio Board (page 9–3).
4. Detach the Console from the Powerbase
(page 9–4).
5. Remove the Power Board (page 9–5).
6. Remove the Interconnect Board (page 9–6).
7. Remove the Pivot Assembly (page 9–9).
8. Using a T-10 6-lobe wrench, remove the two
fasteners holding the Light Pipe in place. Discard the
fasteners. See Figure 9–13.
Installation
Tools Required: T-10 6-lobe wrench
Torque wrench
1. Slide the gasket onto the Light Pipe with
the adhesive side toward the Light Pipe. See
Figure 9–13.
2. Orient the Light Pipe on the Console Base.
3. Using a T-10 6-lobe wrench, install the two fasteners.
Torque to 1.6 N-m (14 in-lbf).
NOTICE
Original fasteners are self-tapping. Replace with
non-tapping fasteners.
4. Install the Pivot Assembly (page 9–9).
5. Install the Interconnect Board (page 9–6).
6. Install the Power Board (page 9–5).
7. Install the Console onto the Powerbase
(page 9–4).
8. Install the Radio Board (page 9–3).
9. Reassemble the PT from the Serviceable Powerbase
(page 8–2).
10. Perform post-service tests (page A–1).
Figure 9–13: Front Light Pipe
Front Light Pipe
20566-00001 (self-tapping)
20972-00001 (non-tapping)
1.6 N-m (14 in-lbf)
Gasket
Console Base
To Next Page
Loading...
