Segway Personal Transporter SE Service Manual
4–5
Tire/Wheel Assembly
x2 SE Turf Hub Adapter
Removal
Tool Required: 13 mm socket wrench
1. Make sure the PT is powered off and unplugged.
2. Support the PT or turn it on its side.
3. Remove the x2 SE Turf Wheel Assembly (page 4–4).
4. Using a 13 mm socket wrench, remove the three
wheel nuts. See Figure 4–4.
5. Lift off the Hub Adapter.
Installation
Tools Required: Isopropyl alcohol wipes
13 mm socket wrench
Torque wrench
1. Make sure the PT is powered off and unplugged.
2. Support the PT or turn it on its side.
3. Inspect the mounting surfaces; use isopropyl alcohol
wipes to clean off all debris.
4. Align the three center holes in the Hub Adapter or
entire x2 SE Turf Wheel Assembly with the lugs on the
gearbox flange. See Figure 4–4.
5. Using a 13 mm socket wrench, thread the wheel nuts
onto the lugs. Torque to 30 N-m (22 ft-lbf).
6. Perform post-service tests (page A–1).
Figure 4–4: x2 SE Turf Hub Adapter
Wheel Nuts
20158-00001
30 N-m (22 ft-lbf)
Hub Adapter
To Next Page
Loading...
