11
4. USE OF THE MACHINE
4.1 Important immediate knowledge
The machine should be:
x used by a person over 18 years old;
x put into service only by a person who has the
knowledge of its particular characteristics and of the
main safety procedures of the machine.
Before starting work with your new machine you should:
a) acquire a good knowledge of the controls and their
operation. Therefore, it is necessary to read that
which is written in the following pages and put it
into practice.
Furthermore whenever You use Your machine it is
important to:
a) Carry out a general check around the machine before
starting your work, making sure that there are no
obstacles that impede its use.
b) Make sure that there is not anybody using the
machine.
c) Check that the auger are not impeded in their normal
functioning by objects that should not be there such
as pieces of wood, stones or other things which could
compromise their attitude.
d) Make sure that all the control press-buttons are in the
neutral position.
e) Make sure that the protection carters are completely
closed.
f) Be sure that:
1) The general switch (1-Fig. 11) is in the
horizontal position (ON);
2) The light (2-Fig. 11) of power supply is on;
Fig. 11
Fig. 12
The machine is delivered with the upper parts
not mounted, it will be customer’s duty to assemble
them. To assemble them it’s enough to check the
position of the screws as shown in Fig. 12
To Next Page
Loading...
