15
2. About Godox Radio System
●
7.
Press the Measuring Button 6.
The ash will re and the measured value (F-stop) will be displayed.
NOTICE
In case of the following, please follow “Cord Flash Mode” ( ).
● When ring the ash, if the ash brightness is lower than the ambient light, the meter
may fail to detect the light.
● Rapid start uorescent lamps and special lighting are sometimes mistaken for ash and
accidentally measured.
● Even if the ash does not re, when a sudden light change occurs in the light receptor,
measurement may be made.
● The waveform of a ash bulb has a slight slope and there is a possibility that the light
meter cannot recognize the ash bulb.
NOTE
● For red-eye prevention and auto-ash light adjustment, some devices can pre-ash
before main ash burst. With the normal setting, the light meter will measure the pre-
ash bursts and not the main ash burst. To take a successful reading, activate the pre-
ash feature in the Tool Box. Please refer to the L-858D Operating Manual.
● For radio CH frequencies, refer to “5. Radio Channel Frequencies”. (
P48)
[Measuring Screen]
Measured value
(F-stop)
To Next Page
Loading...