Sekonic RT-GX - Radio Triggering Multiple (Cumulative) Flash Mode

24
2. About Godox Radio System
●
Operation
1)
How to use Flash Triggering
1.
Touch the [Measuring Mode] Icon on the Measuring Screen.
The Measuring Mode Screen is displayed.
2.
Touch the [Radio Triggering Multi Flash Mode] Icon ( ) in
Measuring Mode Screen.
When it is selected, the display changes to the Measuring Screen.
3.
Set the light receiving method.
Switch to the incident light, extended lumisphere ( )/retracted lumisphere
( ), or reected light.
2-4-2 Radio Triggering Multiple (Cumulative) Flash Mode
This Measuring Mode is used when the light generated by the ash at one time is
inadequate for the desired F-stop setting. Repeated ash pops can be accumulated until
the desired F-stop value is displayed. The measured value (F-stop) is displayed for each
trigger of the ash. The cumulative count is innite. Up to 99 times is displayed in the
Status/Title eld, however, the cumulative count returns to 0 (zero) for more than 100
times (0=100, 1=101, 2=102, etc.).
In the Flash Power Control Screen and Modeling Lamp Power Control Screen, the
Multiple (cumulative) ash measurement is not available (only single measurement is
made).
[Measuring Screen] [Measuring Mode Screen] [Measuring Screen]
[Measuring Mode] Icon