Sekonic RT-GX - Page 27

19
2. About Godox Radio System
●
8.
With [ALL] Button selected, touch [+] or [-] Button.
Press the Measuring Button
6
again.
You can adjust the total power level while the lighting ratio of each Group is being
xed.
NOTICE
● Use the measurement with retracted lumisphere to see the lighting ratio of each Group,
and use the extended lumisphere for nal exposure.
● The measurements between extended lumisphere and retracted lumisphere are different
due to light distribution characteristic. When the lumisphere is switched between
extended and retracted status, the measurement on the main display is cleared.
However, on the ash power control screen, the measurements of each Group remain.
● When the lumisphere is switched between extended and retracted status on any screen
except the ash power control screen, the measurements of each Group are all cleared.
Please extend/retract the lumisphere on the ash power control screen.
NOTE
● To set ISO sensitivity and shutter speed, press the [Radio Triggering Flash Mode] Icon
( ) to return to the Measuring Screen.
● The last selected Group in either Flash Power Control Screen or Radio CH/Group Setting
Screen in Tool Box is activated in Measuring Screen.
Difference in step of output value from the default setting value of 1/16
Output value Difference in Step Output value Difference in Step
1/128 -3.0 1/8 +1.0
1/64 -2.0 1/4 +2.0
1/32 -1.0 1/2 +3.0
1/16 ±0.0
1/1 +4.0
[Flash Power Control
Screen]
[Flash Power Control
Screen]
[+] Button
[-] Button
[ALL] Button
Main Display
Adjusted Value