Selve Commeo Control - English

22
GB
GB
Contents
IMPORTANT:
Read this operating instruction before initial operation. Observe the
safety instructions. SELVE is not liable for changes to the norms and
standards after publication of this operating instruction.
1. Safety instructions .................................................................23
2. General ....................................................................................24
2.1. Designated use ................................................................24
3. Explanation of displays and buttons .................................... 25
3.1. Status LED ........................................................................26
4. Installation ............................................................................... 27
4.1. Connection as a motor controller ..................................29
4.2. Connection as a group controller ..................................30
4.3. Initial operation ................................................................ 31
4.3.1. Runtime setting ......................................................31
4.3.2. Reset runtime .........................................................32
4.3.3. Reset ....................................................................... 32
5. Explanation of functions/terms used ....................................33
5.1. Intermediate position 1 ...................................................34
5.2. Intermediate position 2/tilt position ............................... 35
6. SELVE commeo radio .............................................................36
6.1. commeo initial operation ................................................36
6.1.1. Activate the readiness to learn in the receiver ...36
6.2. Programming/deleting transmitters ...............................36
6.2.1. Search/select the receiver ....................................37
6.2.2. Programming/deleting transmitters .....................38
6.2.3. Exit SELECT mode ................................................38
6.3. Delete transmitter table in the receiver .........................39
7. Disposal ................................................................................... 40
8. Technical data .........................................................................40
9. General declaration of conformity ........................................41
10. Troubleshooting ......................................................................41
11. SELVE Service Hotline ...........................................................41