Selve Commeo Control - Programming;Deleting Transmitters; Exit SELECT Mode

38
GB
GB
SELVE commeo radio
6.2.3. Exit SELECT mode
By pushing the SELECT button for 3 seconds again, you will
leave the SELECT mode. The LED of the commeo transmit-
ter will stop flashing and the transmitter is ready for the
normal operation.
When you do not leave the SELECT mode, the transmitter will ensure
the leaving of the SELECT mode after 2 minutes automatically so that
you can use the transmitter directly at a later time.
3 s
6.2.2. Programming/deleting transmitters
To program or deprogram a transmitter, select the desired channel
and push the PROG button for 1 second. The status LED lights up
green to indicate that the transmitter has been programmed. A red
light means that the transmitter has been deprogrammed.
1 s
Status LED transmitter = green  transmitter
programmed
Status LED transmitter = red  transmitter
deleted