Tufftalk M
17
English
7.3 Using the Mesh in Open Mesh
When Mesh Intercom is enabled, the headset will be in Open Mesh
(default: channel 1) initially.
7.3.1 Channel Setting (Default: channel 1)
If the Open Mesh communication experiences interference because
other groups are also using the channel 1 (default), change the
channel. You can select one of 1 to 9 channels.
1. To enter into the Channel Setting, double tap the Mesh Intercom
Button until you hear a voice prompt, “Channel Setting”.
2. To save one of the channels, tap the (+) or (-) Button to navigate
between the channels until you hear a voice prompt, “(#)”. Then,
tap the Center Button.
(1
2 8 9 Exit 1 )
Note:
• Channel Setting always starts with channel 1.
• If you do not press any button within for approximately 10 seconds in a
specific channel, the channel will be automatically saved.
• The channel will be remembered even if you turn off the headset.
7.4 Using the Mesh in Group Mesh
7.4.1 Mesh Grouping
Creating a Group Mesh
1. Users who want to create a Group Mesh should press and hold
the Mesh Intercom Button for 5 seconds until both users hear a
voice prompt, “Mesh Grouping”.
Headset A Headset #Headset CHeadset B
In Open Mesh
5” 5” 5”
Press Press Press
To Next Page
Loading...
Need help?
General
