Sencon SI9500 - Page 3

6.4 SETTING UP THE RS232 DATA FORMAT .............................................................27
6.4.1 SETTING UP THE EPSON PRINTER ....................................................................... 28
6.4.2 SETTING UP THE TANDY PRINTER ...................................................................... 29
6.4.3 SETTING UP OTHER PRINTERS ............................................................................. 29
6.5 ENABLING THE PRINTOUT....................................................................................29
6.6 SELECTING THE PRINTOUT FORMAT .................................................................30
6.7 PRINTER PROBLEMS.............................................................................................31
7. USING THE SI9500 WITH A COMPUTER............................ 32
7.1 GENERAL.................................................................................................................32
7.2 COMPUTER PORT CONNECTIONS ......................................................................32
7.3 SETUP COMPUTER PORT .....................................................................................33
7.4 SETTING DATA FORMAT AND SPEED .................................................................35
7.5 UNI-DIRECTIONAL PROTOCOL.............................................................................35
7.6 BI-DIRECTIONAL PROTOCOL................................................................................35
7.7 FORMAT OF MESSAGE TRANSMITTED...............................................................36
7.8 ERROR MESSAGES................................................................................................37
8. APPENDIX 1......................................................................... 38
9. APPENDIX 2......................................................................... 42
10. SI9507 FINISHED CAN PROBE........................................... 43
11. ADDENDUM ......................................................................... 44
11.1 MULTI-POINT CALIBRATION..................................................................................44
11.1.1 Introduction .................................................................................................................. 44
11.1.2 Setting for Multi-Point Calibration .............................................................................. 44
11.1.3 Operation...................................................................................................................... 44