47
7 Selecting the mains voltage
Before you plug the mains connector into the mains, please check first of all
that the receiver is set to the correct mains voltage!
You can change the mains voltage by removing the fuse holder
with the inserted fuse ,
turning it through 180°
and inserting it again . The set voltage can be seen at the top of the
fuse holder.
Mains connection
Insert the supplied mains cable into socket on the receiver and pass the cable through the cable
grip .
Because of the cable grip, the cable cannot slip out of socket
and interrupt operation.
Note
A cable grip is particularly important when the receiver is permanently rack
mounted. Inside the rack there are often a large number of cables - a cable grip
prevents the cables from pulling each other out.
To Next Page
Loading...
