Using the EM 300-500 G4
84
▷ Select an unused frequency for one of the connected receiver on the
master receiver.
The frequency selected on the master receiver will also be shown on
the display panel of the connected receivers.
▷ Press the jog dial (SET) on the particular receiver to save your selected
frequency and synchronize it with the corresponding transmitter at a
later point (see “Synchronizing devices”).
or
▷ Press the SYNC button to synchronize the selected frequency with the
transmitter immediately.
▷ Use this procedure to assign an unused frequency to all connected re-
ceivers, one after another.
▷ For the last step, assign a frequency to the master receiver.
This completes the multi-channel frequency setup.
To Next Page
Loading...
