20 Chapter 4: Introduction to AutomationControl
DUG-10009-01 RTM II FlexNet User Guide
• SSI: Signal strength from the base station. A list of SSI ranges.
• Number of inbound retries
Point Data History lets
you see activity of point data, which includes an entry for each point value
reported.
Point Data History shows:
• Point type, index, label, and value
• Scaled point value definitions
• Units of measure
• Any off-normal conditions
•Flags
• Timestamps for when the point data
was reported (Occurred At) and when it was updated (Device
Time)
4.3 Other AutomationControl Features
For more information on the following AutomationControl features, see the AutomationControl User
Guide or application Help.
• Setting up SCADA-Xchange
To Next Page
Loading...