Sequential PRO 3 - Page 61

49
Pro 3 User’s Guide
Modulation
3. Use soft knob 2 to scroll through the various mod sources and choose
mod wheel (As a shortcut you can hold down the source button and
move the Mod wheel.)
4. Use soft knob 3 to set the amount to 30.
5. Use soft knob 4 to scroll through the various mod destinations and
choose lfo1 amt.
6. Hold down a note on the keyboard and turn the Mod wheel. You should
hear vibrato.
Use pressure as the modulation source instead of the Mod wheel in the previ-
ous example to add vibrato with key pressure/aftertouch.
To use the Touch slider to control the lter cutoff:
1. In the modulation section, press the source button. Use soft knob 1 to
scroll to Mod Slot 1 if it’s not already displayed.
2. Use soft knob 2 to scroll through the various mod sources and choose
slider.
3. Use soft knob 4 to scroll through the various mod destinations and
choose cutoff.
4. Hold down a note on the keyboard (or press the hold button and play a
note on the keyboard) and move a nger up and down the Touch slider.
5. Use soft knob 3 to set the amount to your preference. Higher amount
settings cause the lter to open wider the farther up you move your
nger along the Touch slider. A negative amount setting will close the
lter farther up you move your nger along the Touch slider.
Use pressure as the modulation source instead of the Touch slider in the
previous example to open the lter (positive amount) or close the lter (negative
amount) with pressure.