64
Sequencer
Sequential
Sequencing Parameter Changes in Real-Time
The Sequencer makes it easy to record parameter changes in real-time
as part of any of the four phrases/sequences, A,B,C, and D. To do this,
start playback, then hold down the Sequencer’s record button and adjust
front-panel controls such as lter cutoff, noise level, envelope settings,
or other parameters.
As the sequence plays, the Sequencer records the changes to the param-
eter and incorporates them into the sequence. Each parameter you adjust
is assigned to one of the available Sequencer tracks, 4-16. (Tracks 1-3
are reserved for note-related functions, but tracks 4-16 can be freely
assigned.)
Be aware of where and when the sequence loops back around to its
beginning since the Sequencer continues to record (and possibly over-
write) any parameter changes you make as it repeats.
To sequence parameter changes in real-time:
1. Start playback of an existing sequence by pressing the play button.
2. As the sequence plays, hold down the record button and adjust a
parameter (such as lter cutoff) in real-time. Recording loops around
with the sequence, continuously updating the changes you make.
3. As long as you continue to hold down the record button during play-
back you can continue to adjust that parameter or additional param-
eters. Each parameter is assigned to one of the available tracks, 4-16.
To Next Page
Loading...
