59
Pro 3 User’s Guide
Arpeggiator
Repeats: 1, 2, 3 —Set to 1, each note in the arpeggio plays once. Set to
2, each note in the arpeggio plays twice. Set to 3, each note in the arpeg-
gio plays three times.
Clock Parameters
BPM: 30…250—Sets the tempo for the Arpeggiator in BPM (beats per
minute). The tap tempo LED ashes at the BPM rate. When sync is enabled
on the low-frequency oscillator, or enabled in the Effects section, the BPM
rate affects the LFO frequency and/or delay effect. When syncing to an exter-
nal MIDI clock source, the BPM setting has no effect.
Divide—Selects a basic note value relative to the BPM. See the table below:
Name Tempo Timing Division
Half BPM/2 Half note
Quarter BPM Quarter note
8th BPM x 2 Eighth note
8 Trip BPM x 3 Eighth note triplets
16th BPM x 4 Sixteenth note
16 Trip BPM x 6 Sixteenth note triplets
32nd BPM x 8 Thirty-second note
32 Trip BPM x 12 Thirty-second note triplets
64th BPM x 16 Sixty-fourth note
Tap Tempo—Pressing the tap tempo button 4 times sets the tempo. The
LED ashes at the BPM rate you set.
To Next Page
Loading...
