Sequential prophet 5 - Editing and Recording Programs

To
defeat a
voice, hold the
key it is
currently
assigned to
with one
hand while holding
PROGRAM SELECT 1
and
pressing
PROGRAM
SELECT 8.
The
voice
will
be defeated
and
will
remain
defeated
until
the
Prophet's
power
is switched
off. (When power
is
switched
back on,
the
voice
will
not
be
defeated.)
1-9
EDITING
AND
RECORDING
PROGRAMS
NOTE; The
following
directions
are to
simply
get
you started. More information
on
editing and
recording
programs is
in
paragraph
2-1.
While any
program
is
selected,
you can
experiment
with changes to it by
toggling
the
switches
and
adjusting
the
knobs.
This is
"editing." Once
you move a
knob,
it
becomes
"active,"
showing
its
actual
setting
on the
panel.
(Unmoved knobs
do not
necessarily
show
their
actual
setting
in the
current
program.) The
original program
remains
unchanged,
and
can
always
be recalled
by
just hitting its
PROGRAM
SELECT
switch.
In
general,
to
record
an edited
program, the
RECORD switch is
pressed on,
then the
desired destination
BANK and
PROGRAM
location are selected.
NOTE; To protect
the
program
memory
from accidental
erasure, RECORD Mode
can
only be
entered
if the
back panel
RECORD
ENABLE/DISABLE switch is up
(ENABLE).
The switch
should probably
be
left
in
the
DISABLE position until
the
modes of
operation
and
control
functions are
well understood.
This will ensure against
acciden-
tal erasure
of the
original
factory
programs.
However
,
remember that accidental
erasure is not a
disaster,
since the factory
programs
can
be re-programmed into the
Prophet at any
time through
the cassette
interface, as explained in Section
^.
The exact
program-RECORD
procedure
is as follows;
1. Check that the
back panel
RECORD
ENABLE/DISABLE switch is set
to the
ENABLE
(up)
position.
2.
Switch on the orange
RECORD switch in
the
PROGRAMMER
section. It will light.
3. Select the
desired
destination
program file
(1,
2,
or
3),
using the
BANK
and
PROGRAM
SELECT switches.
(Ignore this step
if
the
current file is
desired.)
i^.
Select the desired
bank
using
the
BANK SELECT. (Ignore this
step if
current BANK
is desired.)
5.
At this point
you
can
exit RECORD Mode
by switching the
RECORD switch
off.
The
memory will not
be affected.
6. Otherwise,
press any
PROGRAM
SELECT and
the
program will
be
recorded
at the
corresponding
number in the
selected bank.
NOTE; Be sure
to
hit
the correct
PROGRAM
SELECT
switch or
you may erase a
program you
wanted to
keep.
7.
When a
PROGRAM
SELECT switch has
been hit, the RECORD
LED will go off
and
the
Prophet will
return to the
mode it was in
before
recording.
8.
After
recording a
program,
it is
always a good idea
to
check that
the
program
is
correctly
recorded
in the
desired
location by pressing
the
PROGRAM
SELECT
again.
CMIOOOD
2/82
'
1-5