4-5
PRECAUTIONS
*Use
an AC-supply
with portable recorders.
Use of (weak)
batteries
may cause tape
speed
variations
outside of the interface's
range.
Don't copy
tapes
between recorders.
Instead
load the master
into
the Prophet and
record
the copy
from
the Prophet.
*If using a
stereo
deck,
record
on both channels
simultaneously
to preserve monopho-
nic
compatibility.
(Otherwise,
playback noise
from
an
unrecorded channel could
interfere
with data
loading).
*For
protection
from loss or damage, maintain
a
duplicate
set of
cassettes in
a
safe
place.
>-6
SAVING
TO TAPE
1. Check that the
Prophet's back panel RECORD
switch
is is set
to DISABLE.
2.
Insert cassette into recorder
and rewind
to start of tape.
3.
Check record and playback levels
as discussed above.
k.
Check also cable from CASSETTE OUT to recorder
input.
5. If saving
a
bank only, select
the
bank
before
the one you
want to
record. For
example, to
record
BANK
3,
select BANK 2.
To record BANK
1,
select BANK
5.
6.
Place recorder into record mode and wait
5 seconds for
the tape
leader to
pass.
7.
Hold
the
RECORD
switch, and, if saving
a
bank
only,
press and
hold also the BANK
SELECT switch
as well.
The
BANK display
will now show
the bank
being saved.
Then
press
the SAVE TO
TAPE switch. The
front panel will
go dark,
except the SAVE
TO
TAPE
LED
will remain lit.
8. When,
after
about 40 seconds,
the grey LOAD
FROM TAPE
LED
blinks, STOP the
recorder.
Tape Verification
9. Rewind to start
of tape.
10. Check cable from
recorder output
to
CASSETTE
IN
jack. (If
necessary, check
playback level.)
11. Place recorder
into
play
mode
and wait
10
seconds
for the
tape leader
to pass.
12. Press
the
(blinking)
LOAD FROM TAPE
switch.
13.
The
LOAD FROM
TAPE
LED
will
remain lit.
When
it goes
out, stop
the
recorder.
With
tape
verification completed,
the Prophet
enters
its TUNE
routine
and
will
"come-
up"
with
program
1-1
after
a
few seconds.
CMIOOOD
2/82
'
4-3
To Next Page
Loading...
