Serpent 750 EVO - How to Close the Rear Diff

7
STEp 9
STEp 10STEp 8
M3x3
1- Allow the excess of oil to escape
through the escape holes.
2- Close the holes with the 3x3
setscrews. Tighten carefully.
3- In case the diff feels too hard
remove the M3x3 setscrews and
let some oil escape and close again.
Tighten carefully.
M2.5x10
M3x3
M2.5x10
HOWTOCLOSETHEREARDIFF
1
2
The rear diff top case has two protrusions (see below
picture in red) to hold the geardiff shafts in the correct
position. The protrusion should hold the upper shaft
as it will hold the bottom shaft .
1- Fit the o-ring (see detail view picture in yellow) in the slot of the bottom case using
some silicone oil to hold it in position.
2- Mount the diff top-case on the lower case, make sure to follow below Detail View,
and tighten the screws.
8.2
8.1
Fill the differential with silicone
oil 1 mm above the crosspin,
do NOT overfill. For the correct
cst value please check the default
setupsheet.
Add the big gear.