39
Servonaut AMO has no light
bulb effect. Driving with a trailer
and AMO it is possibly better to
switch off the effect.
Xenon effect
This effect affects the low beam. It simu-
lates the flashing of a xenon lamp. The
setting adjusts the duration of the xenon
effect.
Indicator brightness (20% to 100%)
Adjusts the brightness of the indicators.
Parking light brightness (20% to
100%)
Adjusts the brightness of the parking
light.
US rear lights
For a US rear light the Indicator light,
brake light and rear light (low beam) are
sharing one common output. Parking
lights can be adjusted from 20% up to
80% of brightness. Brake lights and indi-
cators always light up with full bright-
ness. When activated the extra outputs
1 and 2 are automatically used as US-
rear-indicator outputs. In this case the
extra functions 1 and 2 are not available.
Cornering lights (off, 20% to 80%)
Adjustment at which turning angle of the
steering the cornering light is activated
can be done in the gradation 20, 40, 60,
80. For this purpose the steering signal
has to be connected to the LA10.
Settings of brightness are not
supported from AMO
Extra 1
Switch: Extra1 is used as a seperate
switching output.
Parking light/high beam: Extra 1 is acti-
vated at once with the parking light but
strongly dimmed (“sleeping eyes effect”)
Activating the high beam also activates
(overwrites) the extra 1 output but with
full brightness.
Day: Extra 1 is used for daytime running
light. Extra 1 is always activated until
parking light or low beam are activated.
To Next Page
Loading...