19
The Condition Banner can be used for control function as well as pure communi-
cation. There are three choices for each color: Active, Standby, and No Action.
The Condition Banner tab allows the user to choose whether certain parts of the
screen blink or not. Blinking components on the Home screen are intended to
draw more attention to the Condition Banner or the OPERATION indicators. This
is for the purpose of making exception conditions more noticeable to staff con-
cerned with room pressurization status.
Alarm Blink
Denes the behavior of the red ALARM
indicator on the Home screen. Normal
Blink is used for the green NORMAL
indicator.
Warning Blink
Applies to the yellow WARNING, DOOR
indicator.
Blink in Red/Green/Yellow/Blue
Applies to the Condition Banner messages
and icon on the left one-third of the Home
screen.
Full CB Display
If this is selected the left 1/3rd of the
condition banner will become full screen
after 15 seconds. If an alarm is in progress
or occurs while the Condition Banner is
full screen, the standard default screen
will display. Touching the display will
return it to the 1/3rd, 2/3 standard display
mode. This is useful when users want a
very simple interface. Touching the screen
at any time will momentarily display the
Home screen.
Save & Exit
Saves the selections made on this screen.
Condition Banner Tab-
Customizing Blinking
Screens
Used for setting
actions that is
associated with
each banner color
These apply to the right
side of the Home Screen
To Next Page
Loading...
Need help?
General