63
Version 3 2012-08
GB
 The brewing unit is now inserted correctly.
9. Close the brewing unit again with the door.
8.4 Cleaning the bean container
The bean container must be cleaned regularly to prevent contamination. Ide-
ally this is done when the supply of beans is used up and before new beans
are added.
CAUTION!
There is a danger of damage to the device if
objects fall into the bean feed.
– Switch the device off before starting cleaning.
– Do not let any objects fall into the bean feed.
Here's how to clean the bean container:
1. Switch the device off and disconnect the plug.
2. Wipe the bean container with a dry, lint-free cloth.
9. Troubleshooting
In addition to the cleaning messages, the display also shows an appropriate
message in case of a technical fault.
WARNING!
When opening a defective unit, there is a danger
of injury.
– Never repair a defective device yourself. In
case of a technical defect, contact SEVERIN
customer service.
Display Cause Remedy
PLEASE
CLEAN BREW-
ING UNIT.
The brewing unit
must be cleaned.
Clean the brewing unit (►"8.3
Cleaning the brewing unit").
CHECK BREW-
ING UNIT AND
INSERT.
The brewing unit is
not inserted correctly.
Insert the brewing unit (►"8.3
Cleaning the brewing unit").
PLEASE RE-
FILL BEANS.
The bean container
is full.
Fill the bean container with
beans
(►"Preparing coffee speciali-
ties").
BREWING UNIT
DOOR OPEN.
The door of the brew-
ing unit is not closed.
Properly close the door of the
brewing unit.
To Next Page
Loading...
Need help?
General
