SEW-Eurodrive PZM2xA-A075-D02-00 - 3 Sensor;Actuator Box; Design with 4 Slots

3
Sensor/actuator box
Design with 4 slots
Addendum to the Operating Instructions – MOVIPRO
®
– Accessories
20
3 Sensor/actuator box
The sensor/actuator box allows for up to 4 or up to 8sensors/actuators to be connec-
ted to the MOVIPRO
®
, depending on the design. The sensor/actuator box only occu-
pies one port for digital inputs/outputs on the MOVIPRO
®
. To use all digital inputs and
outputs, you must connect 2 sensor/actuator boxes to the MOVIPRO
®
.
The sensor/actuator box provides one connection cable with M23 plug connector and
M12 slots for the sensors or actuators. The green LED "P" indicates the use of the
DC 24 V supply voltage. Each M12 slot is equipped with LEDs for displaying the
status of the inputs/outputs.
The sensor/actuator box is available with different connection cable lengths.
3.1 Design with 4 slots
[1]
[2]
[3]
[4]
14785117835
[1] M12 slot [3] Yellow status display signal1
[2] Operating display LED [4] White status display signal2
3.1.1 Part numbers
Cables Length/installation
type
Component
Length 1m: Part number: 18255477
Length 3m: Part number: 18255485
Cable design: (3X0.75+8X0.34)
M23, 12-pole, male, 0°‑coded↔sensor/actuator box with 4 slots
M12
Fixed length –
23106913/EN – 02/2018