4
External braking resistors
Mechanical installation
Addendum to the Operating Instructions – MOVIPRO
®
– Accessories
29
Flat-type resistors have internal thermal protection (fuse cannot be replaced) that in-
terrupts the current circuit in the event of overload. Additional components for thermal
monitoring are not necessary. The following figure shows an example of a size 1 brak-
ing resistor:
9007201338768011
4.2 Mechanical installation
4.2.1 Mounting position
The following table shows permitted and not permitted mounting positions:
Braking resist-
ors
Mounting positions
BW100-004-00
BW033-012-01
BW050-008-01
BW017-024-02
BW014-028-02
4.2.2 Minimum clearance
Calculate the mounting surfaces, the touch guard and the clearance according to the
high surface temperature. Observe a minimum clearance of 30 mm. Refer to the in-
struction leaflet supplied with the corresponding braking resistor for the required min-
imum clearance dimensions.
23106913/EN – 02/2018
To Next Page
Loading...
