SEW-Eurodrive PZM2xA-A075-D02-00 - Page 32

4
External braking resistors
Mechanical installation
Addendum to the Operating Instructions – MOVIPRO
®
– Accessories
32
4.2.4 Mounting with mounting brackets (sizes 1 and 2)
Required materials
• "Mounting bracket kit, BW" accessories (part number 18229689):
– 4mounting brackets
– 8 M5 × 12 pan head screws
Procedure
INFORMATION
For more information on how to attach the brackets to square pipes or bars, refer to
chapter"Mounting accessories"(→239).
You can use mounting brackets to fasten all braking resistors that are sizes 1 and 2.
Proceed as follows:
1. Use the M5 × 12 pan head screws [1] to attach the mounting brackets [3] to the
braking resistor [2].
[3]
[1]
[2]
2091901579
[1] M5 × 12 pan head screws
[2] Braking resistor
[3] Mounting bracket
2. Ground the housing of the braking resistor.
23106913/EN – 02/2018