Shark ION ROBOT RV700 Series User Manual

10sharkclean.com
ENGLISH
Shark ION ROBOT™ can be charged
three dierent ways:
1 Manually place Shark ION ROBOT on the
charging dock, aligning its charging pads
with the charging contacts on the base.
2 Press the DOCK button on the remote
or robot to automatically send Shark ION
ROBOT to the charging dock.
3 To charge unit directly, plug the charger
into a wall outlet, then connect the charger
cable to the jack on the side of the Shark
ION ROBOT.
BATTERY CHARGE INDICATOR LIGHTS
While the battery is charging, all three blue
LED lights will cycle until fully charged.
Cycles While Charging
Full Charge
Low Charge
Mid ChargeNearly Full
Full Charge
As the unit cleans, its battery discharges.
The blue lights indicate how much charge is
remaining.
Cycles While Charging
Full Charge
Low Charge
Mid ChargeNearly Full
Full Charge
If the red “Replace” light is on, then the battery
needs to be replaced. See page 22 for more
information. If all the battery indicator lights
are off, then either the power switch is turned
off or there is no charge remaining. Turn the
Power switch to the ON position. If all indicator
lights remain off, then charge the unit directly,
using the charger.
Clean
!
Spot
Dock
Replace
!
Replace
Clean
Spot
Dock

Shark ION ROBOT RV700 Series Specifications

General

Brand	Shark
Model	ION ROBOT RV700 Series
Category	Vacuum Cleaner
Language	English