11 1-800-798-7398
SETTING UP YOUR SHARK ION ROBOT™
INSTALLING THE SIDE BRUSHES
1 Turn the unit over.
2 Align hole in center of side brush over brush post on
bottom of unit.
3 Press side brush down over the post until it snaps
into place.
CLICK CLICK
NOTE: Some carpets
may cause the robot to
malfunction due to pile
height.
IMPORTANT: Before
cleaning an entire room
for the first time, we
recommend that you
first test your unit on a
small section of the floor
to ensure there is no
scratching.
IMPORTANT: Shark ION
ROBOT uses cliff sensors
to avoid stairs and other
steep drops. Sensors may
work less effectively when
they are dirty. For best
results, clean sensors as
needed.
TIP: Turn off the power
switch if Shark ION
ROBOT will not be used
for a long period of time.
TIP: To preserve battery
life, unit should be
recharged at least once
every three months.
To Next Page
Loading...
Need help?
General
