sharkclean.eu
ENGLISH
1514
USING THE SHARK® ION ROBOT
BUTTONS AND INDICATOR LIGHTS
DOCK BUTTON
Press to stop cleaning and
send the Robot back to the
charging dock.
CHARGE INDICATOR
Displays the amount of
charge remaining in the
battery.
“!” ERROR INDICATOR
See Troubleshooting section
for full list of error codes.
WI-FI INDICATOR
Blue light: connected to Wi-Fi.
Red light: not connected.
Flashing blue: Set-up mode.
No light: not set up yet.
CLEAN BUTTON
Press to begin a long-running
cleaning session. Press again
to stop.
MAX MODE BUTTON
Press for more powerful
cleaning.
CHARGING THE SHARK® ION ROBOT
USING THE SHARK® ION ROBOT
MANUAL CLEANING MODE
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your
Robot on a small section of the floor to ensure there is no scratching.
NOTE: If the low charge light is blinking red, there is not enough charge for the Robot to return to the
dock. Manually place the Robot on the dock, leaving a 2cm space between the front of the Robot and
the face of the dock.
Turn o the power switch if the Robot is not going to be used for a long period of time, this will help
preserve the battery.
Clean
CHARGE INDICATOR LIGHTS
• The blue charge indicator lights show how much charge is remaining.
• While the Robot is charging, all three blue LED lights will cycle. When charging is complete, all three blue
lights will illuminate steadily.
• If the Robot is idle and away from the charging dock for 10 minutes, it will enter Sleep Mode, and the
lights will turn o.
• If all the indicator lights are o, then the Robot is in Sleep Mode, the power switch is turned OFF (O) or
there is no charge remaining. Turn the power switch ON (I). Press any button to ensure the Robot is not
in Sleep Mode. If all indicator lights remain o, there is no charge. Place the Robot on the dock, leaving a
2cm space between the front of the Robot and the face of the dock. When the Robot is docked correctly
and begins to charge, it will beep and the charge indicator lights will cycle.
Low ChargeMid ChargeNearly FullFull Charge
Low ChargeMid ChargeNearly FullFull Charge
In Use
While
Charging
No Charge
or O
Clean
Max
Dock
Clean
Max
Dock
Clean
Max
Dock
Clean
Max
Dock
Clean
Max
Dock
Clean
Max
Dock
Clean
Max
Dock
To manually start a cleaning cycle:
Step 1: Press the Clean button on the Robot.
Step 2: Press the Dock button to stop the Robot before it finishes
cleaning and automatically returns to the Base.
sharkclean.eu
Low Charge Mid Charge Nearly Full Full Charge
Low Charge Mid Charge Nearly Full Full Charge
To Next Page
Loading...
Need help?
General
