sharkclean.eu
ENGLISH
2120
CLEANING THE MULTI-SURFACE BRUSH-ROLL
MAINTENANCE
Push up on the tabs on the brush-roll access door,
then lift o the door.
Lift out the brush-roll.
Remove the blue cap on the end of the brush-roll.
Do not let the metal cylinder inside the cap fall out.
Clean o any hair or debris, then replace cap. Clean
the brush-roll whenever hair appears.
Reinstall the brush-roll, inserting the flat end first.
Close the brush-roll access door and press down
until it clicks into place.
NOTE: If the metal cylinder falls out of the brush-roll cap, reinsert it in the hole on the inside of the cap.
When cutting away debris, be sure not to cut the brush-roll or any other parts of the Robot
The brush-roll needs occasional maintenance.
Replace brush-roll when visibly worn. See sharkclean.eu for replacement parts.
CLEANING THE SENSORS AND CHARGING PADS
CLEANING THE SIDE BRUSHES
MAINTENANCE
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a damp cloth.
CLEAN SENSORS AND CHARGING PADS AS NEEDED. Clean with a dry cloth or cleaning brush.
Gently dust o the sensors and pads located on the bottom of the Robot.
IMPORTANT: The Robot uses cli sensors to avoid stairs and other steep drops. Sensors may work less
eectively when they are dirty. For best results, clean sensors regularly.
NOTE: Remove any side brushes that are bent or damaged. To remove a brush, lift it o its peg. See
Installing the Side Brushes for instructions on how to attach and remove the brushes.
NOTE: Cloth is not included
sharkclean.eu
To Next Page
Loading...
Need help?
General
