AL-2020/2035/2040/2050/2060 USER PROGRAM 11 - 4
B. Print mode
* The scanning speed increases when the USB 2.0 mode is set to "HI-SPEED", however, the printing speed does not increase considerably.
Program
number
Program name
Setting codes
(factory default setting
appears in bold)
Explanation
1 FORCED
OUTPUT
1: ON
2: OFF
• When this function is enabled, printing in printer mode will automatically
continue using a different size of paper if the specified size of paper runs out
in all trays. This feature does not function in copy mode.
2 USB 2.0 MODE
SWITCH*
1: FULL-SPEED
2: HI-SPEED
• This sets the USB 2.0 data transfer speed. To obtain the fastest speed when
using the USB 2.0 connector, first verify that your computer meets the
system requirements (operating system and driver), and then use this
program to change the USB 2.0 mode to "Hi-Speed". Note that the setting
should not be changed while running a TWAIN driver.
3AUTO TRAY
SWITCH
1: ON
2: OFF
• If the paper runs out during printing and there is paper of the same size in
another tray, this function automatically switches to that tray (excluding the
bypass tray). The function can be disabled.
To Next Page
Loading...
Need help?
General
