15
2
Installation
LOADING COPY PAPER
Side to be
printed
Paper guide
Paper support
4
Make sure the paper release lever is pushed back. The paper will be clamped by the
paper feed roller inside the copier.
When placing special paper or several sheets of paper or when making two-
sided copies, the paper may not be clamped inside the copier even if the paper
release lever is pushed back. In this case, repeat the paper release lever
operation several times to make sure that the paper is clamped.
POWER TO COPIER
1
Ensure that the power switch of the copier is in the OFF position. Insert the attached
power cord into the power cord socket at the rear of the copier.
If you use the copier in a country other than the country where the copier was
purchased, you will need to make sure that the local power supply is compatible
with your model. If you plug the copier into an incompatible power supply,
irreparable damage to the copier will result.
To Next Page
Loading...
