Sharp Aquos LC-32D33X

Press MENU and the MENU screen displays.
1
Checking signal strength and
channel strength
If you install a DVB-T antenna for the fi rst time or
relocate it, you should adjust the alignment of the
antenna to receive a good reception while checking
the antenna setup screen.
Preparation
Press
c
/
d
to select “Setup”.
2
Press
a
/
b
to select “Antenna Setup-
DIGITAL”, and then press ENTER.
3
H
Checking signal strength
Press
a
/
b
to select “Signal Strength”.
Signal Strength
Supply Voltage
Channel Strength
Signal Strength
Quality
Current Max 0
CH No. 21
0
Current Max 0 0
H
Checking channel strength
Press
a
/
b
to select “Channel strength”, and
then press ENTER.
Signal Strength
Supply Voltage
Channel Strength
Signal Strength
Quality
Current Max 0
CH No. 21
0
Current Max 0 0
2 6 5 . 2
MHz
Position and align the antenna so that the
maximum possible values for “Signal Strength”
and “Quality” are obtained.
4
NOTE
• The values of “Signal Strength” and “Quality” indicate when
to check the appropriate alignment of the antenna.
12
32D33X_en_b.indd 1232D33X_en_b.indd 12 2008-1-24 14:52:312008-1-24 14:52:31