Sharp Aquos LC-32D33X

54
Repeat steps 1 to 3 in AQUOS LINK Auto
power on.
1
Press
a
/
b
to select “Selecting Recorder”,
and then press ENTER.
2
Select the recorder, and then press ENTER.
3
Selecting recorder
You can select a recorder for the recording from
several connected recorders.
AQUOS LINK
Press MENU to exit.
4
Auto Power On
Selecting Recorder
Using Genre Info.
INPUT3
INPUT4
[1. 0. 0. 0]
[2. 0. 0. 0]
NOTE
• If you have connected the 1 BIT THEATER RACK SYSTEM
(AQUOS AUDIO) between the TV and an AQUOS Recorder,
the input source’s indication changes from “INPUT3” to
“INPUT3 (Sub)” as it is shown below.
Auto Power On
Selecting Recorder
Using Genre Info.
INPUT3
INPUT3 (Sub)
INPUT4
[1. 0. 0. 0]
[1. 1. 0. 0]
[2. 0. 0. 0]
Repeat steps 1 to 3 in AQUOS LINK Auto
power on.
1
Press
a
/
b
to select “Using Genre Info.”, and
then press ENTER.
2
Press
c
/
d
to select “On”, and then press
ENTER.
3
Using Genre Info.
This function allows you to automatically switch to
the appropriate sound mode depending on the genre
information included in the digital broadcast.
Operating an AQUOS LINK device
AQUOS LINK allows you to operate the HDMI-
connected device with one remote control.
Use the following procedure to start playback.
Press PLAY
I
to start playback of a title.
• See page 43, section “Playback of titles using
AQUOS LINK” if you want to start playback using
the list of the titles of the AQUOS BD Player/
AQUOS Recorder.
1
Press FWD
J
to fast forward.
Press REV
G
to reverse.
Press STOP
H
to stop.
Press POWER to turn the HDMI-connected
device on/off.
2
Press OPTION and the AQUOS LINK menu
screen displays.
1
Press
a
/
b
to select “By AQUOS AUDIO SP”,
and then press ENTER.
2
Listening with the 1 BIT THEATER RACK
SYSTEM (AQUOS AUDIO)
You can opt to listen to the TV sound only from the 1
BIT THEATER RACK SYSTEM (AQUOS AUDIO).
• The sound from the TV speaker and headphone
terminal is silenced and only the sound from the 1
BIT THEATER RACK SYSTEM (AQUOS AUDIO) is
audible.
• You can use VOL
k
/
l
and MUTE (
e
).
AQUOS LINK Menu
Recorder EPG
Top Menu/Title List
Media change
By AQUOS AUDIO SP
By AQUOS SP
Sound mode change
Model select
Use the following procedure to start recording.
Check the following items before recording.
• Make sure the antenna cable is connected properly.
• Check if the recording media (HDD, DVD, etc.) has enough
capacity for recording a programme.
• Select the equipment for recording in Selecting Recorder.
Press REC
E
to record a programme.
Press REC STOP
H
to stop recording.
2
3
After you selected recording media (HDD,
DVD, etc.) in the menu, please make sure the
recording menu in the ready condition.
1
32D33X_en_h.indd 5432D33X_en_h.indd 54 2008-1-31 12:37:212008-1-31 12:37:21