Sharp Aquos LC-32D33X

30
Watching TV
Auto power-off at a designated time
This function is conveniently used when, for instance,
going to bed while watching TV.
1
2
Sleep timer: Remain 2hr. 00min.
NOTE
• The sleep timer indicator on the TV lights up when the time
has been set.
• When the time has been set, countdown automatically
starts.
• Five minutes before the preset of time expires, the
remaining time displays each minute.
• Select “Off” by pressing SLEEP to cancel the sleep timer.
Press SLEEP.
• Remaining time displays when sleep timer has
been set.
Each time you press SLEEP, the remaining
time switches as shown below.
0hr. 30min. 1hr. 00min. 1hr. 30min.
2hr. 30min. 2hr. 00min.
Off
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Power Control”.
2
Press
a
/
b
to select “No Signal Off”, and then
press ENTER.
3
Press
c
/
d
to select “Enable”, and then press
ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
4
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Power Control”.
2
Press
a
/
b
to select “No Operation Off”, and
then press ENTER.
3
Press
a
/
b
to select “30 min” or “3 hr”, and
then press ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
4
NOTE
• “Disable” is the factory preset value.
Auto power-off when there are no
operations performed
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours.
NOTE
• “Disable” is the factory preset value.
• When a TV programme fi nishes, this function may not
operate.
Auto power-off after the end of broadcast
You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving
no programme signals, such as the end of a broadcast
day.
Energy conservation settings
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Power Control”.
2
Press
a
/
b
to select “Ecology”, and then
press ENTER.
3
Press
c
/
d
to select “Yes”, and then press
ENTER.
Ecology
When set to “Yes”, The TV activates the following
power saving mode.
• “OPC” set to “On” (Page 35)
• “Standby Mode” set to “Mode 2” (Page 31)
• “No Operation Off” set to “3 hr” (Page 30)
• “No Signal Off” set to “Enable” (Page 30)
NOTE
• Ecology mode cannot be deactivated by selecting “No”.
Each setting must be changed individually to deactivate
Ecology mode.
4
32D33X_en_d.indd 3032D33X_en_d.indd 30 2008-1-25 15:19:332008-1-25 15:19:33