Sharp Aquos LC-46LE700X

30
Watching TV
Energy conservation settings
Auto power-off at a designated time
This function is conveniently used when, for instance,
going to bed while watching TV.
1
Press SLEEP.
• Remaining time displays when sleep timer has
been set.
Sleep Timer: Remain 2 hr. 00 min.
2
Each time you press SLEEP, the remaining
time switches as shown below.
0
h
r.
30
m
i
n. 1
h
r.
00
m
i
n. 1
h
r.
30
m
i
n.
2 hr.
30
min. 2 hr.
00
min.
Off
NOTE
• When the time has been set, countdown automatically
starts.
• Five minutes before the preset of time expires, the
remaining time displays each minute.
• Select “Off” by pressing SLEEP to cancel the sleep timer.
ECO picture control
This function automatically detects the image source
and decreases the power consumption while keeping
the brightness of the image unchanged.
1
Press MENU and the MENU screen displays.
2
Press
c
/
d
to select “ECO”.
• ECO menu displays.
3
Press
a
/
b
to select “ECO picture control”,
and then press ENTER.
4
Press
c
/
d
to select “On” or “Off”, and then
press ENTER.
NOTE
• This function does not work when “AV MODE” is set to
“DYNAMIC (Fixed)” or “AUTO”.
• This function does not work when “Energy save” is set to
“Standard” or “Advanced”.
Energy save
This function enables you to automatically reduce the
backlight brightness in order to decrease the power
consumption and increase the backlight life span.
1
Press MENU and the MENU screen displays.
2
Press
c
/
d
to select “ECO”.
• ECO menu displays.
3
Press
a
/
b
to select “Energy save”, and then
press ENTER.
4
Press
a
/
b
to select “Standard” or
“Advanced”, and then press ENTER.
Selected item Description
Standard Reduces the backlight brightness by
25%.
Advanced Reduces the backlight brightness by
50%.
Off The backlight brightness is the same
value of your settings in the selected “AV
MODE”.
Auto power-off after the end of broadcast
You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving
no programme signals, such as the end of a broadcast
day.
1
Press MENU and the MENU screen displays.
2
Press
c
/
d
to select “ECO”.
• ECO menu displays.
3
Press
a
/
b
to select “No signal off”, and then
press ENTER.
4
Press
c
/
d
to select “Enable”, and then press
ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• “Disable” is the factory preset value.
• When a TV programme finishes, this function may not
operate.
Auto power-off when there are no
operations performed
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours.
1
Press MENU and the MENU screen displays.
2
Press
c
/
d
to select “ECO”.
• ECO menu displays.
3
Press
a
/
b
to select “No operation off”, and
then press ENTER.
4
Press
a
/
b
to select “30min.” or “3hr.”, and
then press ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• “Disable” is the factory preset value.
LC46LE700X_EN.indb 30LC46LE700X_EN.indb 30 11/23/2009 1:00:27 PM11/23/2009 1:00:27 PM