– E-4 –
If service should be required on this calculator, use only a
SHARP servicing dealer, SHARP approved service facility, or
SHARP repair service where available.
Hard Case
DISPLAY
•
During actual use, not all symbols are displayed at the same
time.
• Only the symbols required for the usage under instruction are
shown in the display and calculation examples of this manual.
/
:
Appears when the entire equation cannot be displayed.
Press
<
/
>
to see the remaining (hidden) sec-
tion.
xy/r
θθ
θθ
θ
: Indicates the mode of expression of results in the
complex calculation mode.
: Indicates that data can be visible above/below the
screen. Press [/] to scroll up/down the view.
2ndF : Appears when @ is pressed.
HYP : Indicates that h has been pressed and the hyper-
bolic functions are enabled. If @H are pressed,
the symbols “2ndF HYP” appear, indicating that in-
verse hyperbolic functions are enabled.
ALPHA: Appears when K (STAT VAR), O or R is
pressed.
FIX/SCI/ENG: Indicates the notation used to display a value.
DEG/RAD/GRAD: Indicates angular units.
: Appears when matrix mode is selected.
: Appears when list mode is selected.
: Appears when statistics mode is selected.
M:Indicates that a value is stored in the independent
memory.
Exponent
Equation→
Display
Mantissa
←Symbol
EL5060E_En0616.pm65 06/16/2004, 13:104
To Next Page
Loading...
