Sharp FP-J50 - Specifications; Product Specifications Table; Standby Power Information

EN-11
ENGLISH
Model FP-J50
Power supply
220 - 240 V 50 - 60 Hz
Fan speed Adjustment
MAX MED
SLEEP*
2
Fan Speed (m
3
/hour)
306 186 48 ~ 120
Noise Level (dBA)*
1
51 39 15 ~ 30
Rated Power (W)
39 14 4.5 ~ 7.5
Standby Power (W)
1.6 (When Wi-Fi adapter is ON.)
1.2 (When Wi-Fi adapter is OFF.)
Recommended Room Size (m
2
)*
3
~ 40
High density Plasmacluster ion
recommended room size (m
2
)*
4
~ 23
Filter type
HEPA*
5
/ Deodorizing
Sensors Sensitive Dust / Odor / Temperature / Humidity / Light
Cord Length (m) 2.0
Dimensions (mm) 390 (W) x 270 (D) x 583 (H)
Weight (kg) 6.4
*1 • Noise level is measured based on the JEM 1467 standard of the Japan Electrical Manufacturers’ Association.
*2 • The fan speed is automatically switched depending on the amount of impurities in the air and room brightness.
*3 • The recommended room size is appropriate for operating the main unit of maximum fan speed.
• The recommended room size is an area in which a given amount of dust particles can be removed in 30 minutes
(according to JEM1467).
*4 • Room size in which approximately 7000 ions per cubic centimeter can be measured in the center of the room when
the main unit is placed next to a wall, is running at MED mode settings, and is at a height of approximately 1.2
meters from the floor.
*5 • The filter removes more than 99.97% of particles at least 0.3 microns in size (according to JEM1467).
Standby Power
When the main unit’s power plug is inserted in a wall outlet it consumes standby power
in order to operate electrical circuits. To conserve energy, unplug the power cord when
the main unit is not in use.
SYMPTOM REMEDY (not a malfunction)
One of the following indicator lights is
flashing.
• Unplug the main unit, wait one minute, and then plug the main unit in
again.
SPECIFICATIONS
FP-J50_EN.indd 11 2020/08/31 14:28:43