EN-6
OPERATION
SLEEP MED MAXAUTO
The main unit operates at HIGH fan speed for 60 minutes and then alternates between Low and High level for 20
minutes each.
START STOP
• Select the desired fan speed.
• When the main unit starts operation, the operation
starts in the previous mode it was operated in.
10 minutes: Max High fan level
50 minutes: High fan level
20 minutes: Low fan level
20 minutes: High fan level
• The Plasmacluster Ion cannot be turned “OFF”.
• It is possible to switch this mode to another while
operating.
However, the HAZE mode will not function after
switching mode.
• You can also set the timer in
designated App.
If the timer has already been set
in designated App, all TIMER
indicator lights of the product turn
on. You cannot set the timer in the
product.
Select the length of time you want, with the main unit on. The main unit automatically stops once the selected time
is reached.
START/STOP
HAZE
FAN SPEED
OFF TIMER
NOTE
NOTE
NOTE
(with the main unit ON)
2hour 4hour 8hour CANCELLATION
AUTO
SLEEP
The fan speed is automatically controlled depending on the 3 detection.
(Dust / Odor / Light)
The main unit will operate very quietly, and the fan speed is
automatically switched depending on the amount of impurities in the air
and room brightness.
Cleanliness Monitor / Plasmacluster Ion Light go off automatically.
Even though the indicator is off, Plasmacluster Ion is dispersed into air
unless Plasmacluster Ion is turned off by
.
OFF
FP-J50_EN.indd 6 2020/08/31 14:28:40
To Next Page
Loading...
Need help?
General
