Sharp FP-J50 - Light and Plasmacluster Ion Control; Adjusting Light Settings; Controlling Plasmacluster Ion; Sensor Detection Sensitivity

EN-7
ENGLISH
1
(with the main unit OFF)
2
Sensitive dust sensor / Odor sensor Light sensor
3
You can set the Cleanliness Monitor / Plasmacluster Ion Light to OFF when they are lighting up.
When Plasmacluster Ion is ON, the Plasmacluster Ion Light will turn on. (blue)
OFF
more than 3 sec.
LIGHT CONTROL
PLASMACLUSTER ION ON/OFF
ADJUSTMENT OF SENSOR DETECTION SENSITIVITY
ON
more than 3 sec.
(with the main unit ON)
• When the main unit starts operation,
the operation starts in the previous
mode it was operated in.
1
(with the main unit ON)
NOTE
• If the HAZE Button is not pushed within 8 seconds,
the setting will be saved automatically.
• When the main unit starts operation, the operation
starts in the previous mode it was operated in.
2
AUTO
Light automatically switches ON or OFF based on
room brightness.
Room is bright: light is ON
Room is dark: light is OFF
OFF
When set to “OFF”, the “DIM” light illuminates for
8 seconds after operation starts and then the light
turns off.
more than 3 sec.
AUTO
DIM
OFF
NOTE
NOTE
You can change the sensitivity of the Sensitive dust sensor / Odor sensor and the Light sensor .
more than 3 sec.
Standard High Low Standard High Low
• If the power ON/OFF Button is not pushed within 8 seconds of
adjusting sensor sensitivity, the setting will be saved automatically.
• The sensor sensitivity setting will be saved even if the main unit is
unplugged.
FP-J50_EN.indd 7 2020/08/31 14:28:41