Sharp HT-SB116 User Manual

E-18
Auto power on function works only
during standby mode. It will not
work if the sound bar is in low power
consumption mode .
Optical In:
Turn off the external source. The
sound bar will automatically power
on if the external source is turned on
again.
The sound bar will automatically go
to standby mode if:
Optical In:
No audio signal is detected after
approximately 15 minutes.
Bluetooth:
Not connected condition, in the
pause or stop mode and no
incoming signal from device after
approximately 15 minutes.
USB:
In the stop mode or no USB device
is plugged in after approximately 15
minutes.
Bass control:
1. Press the BASS button.
2. Within 5 seconds, press the + / -
button to adjust the bass.
Treble control:
1. Press the TREBLE button.
2. Within 5 seconds, press the + / -
button to adjust the treble.
 Auto power on function
 Auto power off and auto
detect signal
 Bass and treble control
(remote control)
General control (continued)

Sharp HT-SB116 Specifications

General

Brand	Sharp
Model	HT-SB116
Category	Speaker System
Language	English