04/10/16 HT-X1H(H)E5.fm
E-43
ENGLISH
TINSZA030SJZZ
HT-X1H
Radio
Listening to the radio (continued)
! Memorising a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead get dis-
connected.
! To recall a memorised station
To select a preset station with the direct number buttons:
Example:
To select 28, press "2", "8" and "ENTER".
! To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
! To erase entire preset memory
1
Perform steps 1 - 3 in "Tuning" on page 42.
2
Press the ENTER button to enter the preset tuning saving
mode.
3
Within 5 seconds, press the TUNER PRESET ( or ) but-
ton to select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 5 seconds, press the ENTER button to store that
station in memory.
If the "PROGRAM" and preset number indicators go out before
the station is memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorised will be erased.
Press the TUNER PRESET ( or ) button for less than 0.5 sec-
onds to select the desired station.
1 Press the corresponding number ("0" - "9").
2 Press the ENTER button.
1 Press the TUNER PRESET ( or ) button for more than 0.5
seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the TUNER PRESET ( or ) button again when the de-
sired station is located.
1 Hold the CLEAR button down for 4 seconds or more.
2 Within 10 seconds, press the ENTER button.
To Next Page
Loading...
