Sharp HT-X1H

04/10/16 HT-X1H(H)E6.fm
E-53
ENGLISH
TINSZA030SJZZ
HT-X1H
Advanced Features
Changing the default setting of the amplifier
Change settings according to the connected speakers.
Speaker delay setting (See page 54.)
Speaker level setting (See page 55.)
Test tone (See page 55.)
Example:
If the right surround speaker is 3.3 m away from the listening posi-
tion, change settings as shown below (adjust the SR).
Default settings:
Delay - - - 2 m
Level - - - 0 db
1 In "Speaker delay setting", set the right surround speaker (SR)
to 3.3 m.
2 In "Speaker level setting", slightly increase the level of the right
surround speaker as it is a little farther than others (see page
55).
3 In "Test tone", check the sound from each speaker (see page
55).
FL
FR
SL
Default setting: 2 m
SR
SW
CT
FL
FR
SL
SR
SW
CT
3.3 m
Speaker type Delay range Level range
FL Front speaker (Left) 0.1 to 9.0 m - 6 db to + 6 db
CT Centre speaker 0.1 to 9.0 m - 6 db to + 6 db
FR Front speaker (Right) 0.1 to 9.0 m - 6 db to + 6 db
SR Surround speaker (Right) 0.1 to 9.0 m - 6 db to + 6 db
SL Surround speaker (Left) 0.1 to 9.0 m - 6 db to + 6 db
SW Subwoofer/amplifier unit - 10 db to + 10 db
If you press during
the operation, you
can go back one step.