Preparation
Antennas
To enjoy a clearer picture, use
an
outdoor antenna. The following
is
a brief explanation of the types of connections
that are used for a coaxial cable.
If
your outdoor antenna uses a 75-ohm coaxial cable with
an
F-type connector,
plug it into the antenna terminal at the rear of the
1V
set.
300-ohm twin-lead cable
(flat)
IF-type
connector
----oct}
75-ohm coaxial cable (round)
1.A
75-ohm system
is
generally a round cable with F-type connector
that can easily be attached to a terminal without tools (Commercially
available).
2.
A 300-ohm system
is
a flat "twin-lead" cable that can be attached
to
a 75-ohm terminal through a 300175-ohm adapter (Commercially
available).
ED
F-type connector should be finger-tightened only.
When connecting the
RF
cable to the
1V
set, do not tighten F-type
connector with tools.
If tools are used, it may cause damage to your
1V
set.
(The
breaking
of internal circuit, etc.)
~~~type
coonector
75-ohm coaxial cable
Connecting Antenna
Cable
• Connect the antenna cable
to
the TV using one of the methods
in
the illustration as shown
(CD,
®, @ or @).
I
DIGITAL AUDIO
J-U-4~~~-:=iiiiOUT
..
PUT
.....
__
..
~t
I~I
300nS.-ohm
adapter
(commercially available)
•
I
or
I
3DO-ohm
twin-lead cable
300-0hm twin-lead
cable
(flat)
75-ohm
coaxial
cable
(round)
Home
Antenna
terminal
(7S-ohm)
....
ca.bl
..
elV
...
lea.d
...
I"
...
[jj
~===\l==«O
Coaxial
cable
{commercially available)
Home
Antenna
7S-ohm
coaxial
cable
(round)
terminal
(75-ohml
"""'--------
[!il e-===\l==<J
Coaxial
cable
(commercially available)
~~:::3:00:.0:hm='~:=~:i:.:~:a:::':~:~I:e-~<
'~<
~~::r
~~:~:~~ja:~TailoabITVeJ
antenna
_
Jor
7S-ohm
coaxial
cable
terminal
VHF
UHF
ANTENNA
ANTENNA
® VHF/UHF antenna
CD
Cable without a CATV
converter
@ Combination
VHF/
UHF antenna
@ Separate VHF/UHF
antenna
Installing Batteries
in
the Remote Control Unit
If
the remote control fails to operate
TV
functions, replace the batteries
in
the remote control unit.
1 Open the battery cover. 2 Insert
two
"AA"
size
batteries 3 Close the battery cover.
(supplied with the product).
I
(±)
\\--
+
~i~'
• Place the batteries with their terminals
corresponding to the (
+)and (- )
indications
in
the battery compartment.
mm
Improper use
of
batteries can result
in
chemical leakage or explosion. Be sure
to
follow the instructions below.
• Do not mix batteries
of
different types. Different types of batteries have different characteristics.
• Do not mix old and new batteries. Mixing old and new batteries can shorten the
life
of
new batteries
or
cause chemical leakage
in
old batteries.
• Remove batteries as soon as they are worn out. Chemicals that leak from batteries that come
in
contact with skin can cause a
rash. If you find any chemical leakage, wipe thoroughly with a cloth.
• The batteries supplied with this product may have a shorter life expectancy due to storage conditions.
•
If
you will not be using the remote control unit for an extended period of time, remove batteries from
it.
@-8
To Next Page
Loading...
