On-Screen Display
Menu
Setup Menu
Example
1 Press MENU to display the MENU screen, and then
press
li/'~
to
select "Setup" and press ~
to
enter
it.
2 Press
~l~
to
select a specific adjustment item and
press
~
to
enter the setting.
3 Press
~/~
to
select the setting and press
ENTER
to
confirm the change.
4 Press MENU to exit.
Language Setting
You can also select a language from the Setup menu.
Select from among 3 languages: English, French and
Spanish.
Auto
CH
Search Setting
If initial setup does not memorize
all
the channels
in
your region, follow the instructions below to manually
memorize the channels.
Air/Cable: Make sure what kind
of
connection
is
made
with your
IV
when selecting Air
or
Cable.
• When Air
is
selected, the
IV
detects antenna signals.
It
searches for NTSC and ATSC channels available
in
your area.
• When Cable is selected, the
lV
detects signals
supplied by cable.
It
searches for NTSC, ATSC, and
QAM modulated channels available
in
your area.
Input Source Setting
Lets you set the input terminal displayed when using
the Input source menu or channel display. Press
IIiJ~
to
select the
new
name for the input mode.
ImD
•
If
INPUT 7
is
selected without signal input, then the
IV
will
turn off automatically after
30
seconds approximately.
Clock
Setting
This function allows you
to
use the
1V
as a clock.
Use
Ji'/"
to
set the time (Hour/Minute/AM
or
PM) and
press
ENTER
to
confirm the change.
Favorite Channels Setting
(only
in
TV
mode)
This function allows you
to
program 4 favorite
channels,
in
4 different categories. By setting the
favorite channels
in
advance, you can select your
favorite channels easily.
To register your favorite channel:
1 Press MENU on the remote control and select
"Setup"I"Favorite channels".
2 Press
./
..
to select your desired channel and press
~
or
the ENTER button
to
confirm.
To delete your favorite channel:
1 Press MENU on the remote control and select
"Setup"I"Favorite channels".
2 Press
.1"
to select
"All
data clear" and press
~
to
start clearing
all
favorite channel data.
ImD
• Before setting the channel, select the channel you want
to
register as a favorite channel.
• While watching, you can toggle the selected channels
by
pressing the
A,
B, C and D button on the remote control.
Current Software Info
This function displays
1V
software information.
Reset
If complex adjustments are made and the settings
cannot be restored
to
normal, you can reset the
settings
to
the factory preset values.
1mB
• The channel setup settings will not be changed.
• The language setting will not be changed.
• The
PIN
number setting will not be changed.
Picture Adjustment Setting
(only
in
PC
mode)
Auto adjust: Automatically adjusts picture to the best
image position, phase, and clock setting.
Manual adjust: Allows
to
manually fine tune the image
as it appears on the screen.
• Phase: Eliminates the horizontal interfering lines.
• Clock: Eliminates the vertical interfering lines.
• Horizontal: Adjusts the horizontal placement
of
the
picture:
• Vertical: Adjusts the vertical placement
of
the
picture.
@-
23