On-Screen Display Menu
On-Screen Display Menu Operation
Example
Example
~I~~~'-CD
®
@
The bar above
is
an
operational guide for
the remote control. The bar will change
in
accordance with each menu setting screen.
• Exit
• Next
o Previous
G)
Item displayed
in
yellow
• This indicates the item currently selected.
• Press
~
to
go
to
the adjustment screen for this item.
® Item displayed
in
white
• This indicates that the item can be selected.
® Item displayed
in
gray
• This indicates that the item cannot be selected.
There are various reasons
why
the items cannot
be
selected, but the main reasons are as follows:
- Nothing
is
connected to the selected input terminal.
- The function
is
not compatible with the current input
signal.
G)
Press
~/~
to enter the desired item or return to
the upper level menu.
® Press
£,/T
to
select the desired item.
® Press
£,/T
to
adjust the item.
mm
• Menu options differ
in
the selected input modes, but the
operating procedures are the same.
• The screens
in
the operation manual are for explanation
purposes (some are enlarged, others cropped) and may
vary slightly from the actual screens.
Menu Operation Buttons
Using the remote control
Use the following buttons on the remote control to
operate the menu.
Using the control panel of the main unit
You can also operate the menu with the control panel
of the main unit.
Button operations on the control panel correspond to
the ones on the remote control as shown below.
VOL +/- : Cursor
....
/~
on the remote control.
CH
V//\:
Cursor T/1I;. on the remote control.
MENU:
1I;./T/
....
/~:
ENTER:
RETURN:
Press to open or close the menu screen.
Press to select a desired item on the screen or
adjust a selected item.
Press to
go
to
the next step or complete the
setting.
Press to return
to
the previous step.
MENU: MENU on the remote control or ENTER on
the remote control while OSD menu is on.
MENU
o
'"PUT
o
0"
@-
18
To Next Page
Loading...
Need help?
General